Further drag reductions on Standard Cirrus wing (10/18/2003)
On October 18 a flight test of Standard Cirrus #60 (N2866) yielded two positive outcomes.
First, the already impressive profile drag reductions of September 17 were essentially doubled
at airspeeds over 70 kts and greatly improved below 50 kts. This was achieved by modifying the construction
and configuration of the Sinha deturbulator used earlier. Fig. 13 illustrates this dramatic improvement.
As before, the green curve is the clean wing,
the gold curve, in this case, is the drag measured on September 17,
and the red curve is the October 18 deturbulator test.
The broken curves show the percent reduction in drag for the correspondingly colored drag curves.
These are plotted against the right side scale. As before the drag data is reported in Volts
which is proportional the drag.
Figure 13. Drag vs airspeed* with and without deturbulator
on lower surface of Standard Cirrus wing. (10/18/2003)
Aside from the stunning high speed reductions, the low speed improvement essentially leveled the
performance boost across the entire range of airspeeds!
The points of greatest improvement were 27.3% at 60 kts, 26.7 at 70 kts
and 26.2% at 100 kts where the trend was upward. Vne for this ship is 119 kts.
The average for speeds over 50 kts was 23.7%.
The second positive outcome was that, for the first time, we had substantial success on the suction side of the wing.
This was the sixth attempt on the upper surface. The previous three tries produced incremental but small improvements.
The fifth attempt gave an encouraging 20% improvement at 100 kts, but fell off sharply to nothing at 80 kts and
produced moderate drag increases at lower speeds.
Since we use the drag rake on only one surface at a time, we had the upper pitot openings taped over
for this flight. However oil flows showed that the distinct upper surface separation bubble was
mostly eliminated. Only a few localized spots of weak bubble activity remained. We intend to take
drag rake data for the suction side on the next flight test. Improvements on the top surface are not expected to
be as dramatic. If this holds true, it will be a shame because clean wing measurements indicate that the suction
side produces more drag than the pressure side, three times as much at 40 kts, two times at 50 kts and
1.5 times at high speeds.
The reader will be excused for viewing this in disbelief. Time will tell.